LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 45 (63 Bumper - Wagon -- 971 - PANAMERA (971)) >> WM, 635719 Removing And Installing Rear Retaining Strip >> Installing Centre Retaining Strip And Retaining Strip For Tail Light

Installing Centre Retaining Strip And Retaining Strip For Tail Light

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order.
  2. Screw in and tighten nuts on retaining strip for tail light > Tightening torque 3.5 Nm (2.6 ftlb.) 
  3. Screw in and tighten nut on centre retaining strip at the bottom > Tightening torque 3.5 Nm (2.6 ftlb.) 
  4. Screw in and tighten nuts on centre retaining strip > Tightening torque 6 Nm (4.4 ftlb.) 
scientia non olet · About LEMON Manuals