Installing Rear Apron
WARNING: This page is about a different variant/trim than selected.
Information
Always replace self-locking screws.
- Installation is performed in reverse order. Pay particular attention to the following:
Tightening torque for screws securing rear apron to retaining frame: > Tightening torque 3 Nm
Tightening torque for screw securing rear apron to side panel: > Tightening torque 7 Nm
Tightening torque for screws on tail light trim panel: > Tightening torque 6 Nm
Tightening torque for screw securing rear apron to frame for light: > Tightening torque 3 Nm