General Assembly Instructions
WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Information
The pictures and graphics shown may differ from the original depending on engine variants, additional equipment and/or country specifications.
However, the technical accuracy of the specifications is guaranteed.
- Unless expressly permitted, do not oil the thread or coat it with screw-locking agent.
- For assembly, coat O-rings (except for injector) or relevant contact surfaces with Kluber Syntheso Glep 1 (000.043.204.68).
- Coat injector O-rings or relevant contact surfaces with engine oil SAE 0W-40 (N.052.578.00).
- Replace seals following removal.
- Coat water hoses and rubber sleeves with Kluber Syntheso Glep 1 as required.
- For assembly, coat fuel lines and fuel pressure sensors in accordance with instruction 0P2.100.991 with Microgleit DF 977 S (000.043.209.35).
- The cylinder liner, piston and piston rings must be coated with SAE 0W-40 engine oil (N.052.578.00) for assembly.
- Coat main bearing, valve stem, valve drive, high-pressure pump and intermediate shaft with SAE 0W-40 (N.052.578.00) during assembly.
- Coat connecting-rod bearings and camshaft bearings with Renolit MP 735 (N.052.735.00) during assembly.
- For assembly, coat the crankshaft axial bearing with Castrol Optipit (000.043.204.17).