Teaching While Driving
WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
A procedure in > 9900 - PIWIS Tester 3 can be used to teach the wheel IDs while driving: >>Tyre Pressure Monitoring (TPM) system <<>>Maintenance/repairs<<>>Teach wheel IDs<<>>Teach wheel IDs while driving<<.
The wheel IDs can also be taught without using the System Tester.
The following points must always be observed:
- Allow an idle time of at least 5 minutes before teaching the wheel IDs (wheel electronics units are then in Sleep mode).
- Briefly accelerate the vehicle to over 25 km/h (15 mph) in order to teach the wheel IDs (wheel electronics units are then in Burst mode).
- Then continue driving at any speed (even < 25 km/h or 15 mph) for max. 10 minutes.
- Teaching was successful if a pressure reading is displayed in the instrument cluster for all wheel positions.