Installing Filler Flap (Module)

Information 

Check that the rubber sleeve -1-  is fitted correctly.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rubber sleeve on filler flap (module)

1. Affix a continuous length of 3-mm butyl cord -1-  all around the side section flange.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Butyl cord

   1. 1.1 Affix butyl cord -1-  in such a way that areas -2-  remain clean.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Butyl cord

2. The rest of the installation steps are performed in reverse order.
3. Tighten screws to > Tightening torque 8 Nm (6 ftlb.)  .