Preparing Front Rear-End Well
Information
The rear rear-end well is supplied with a pre-applied adhesive bead as a spare part, which means that the adhesive bead also needs to be cut back during replacement.
Information
- The surface coating of adhesive residue helps new adhesive to stick. Keep cut surfaces clean and free of grease and do not clean with cleaning solution.
- Fit cutting tool with the flashing knife and remove adhesive residues -3-
, ensuring that a surface coating of adhesive residue remains -3-
.
Front rear-end well
- If the adhesive bead is left for more than 24 hours after being cut back: Apply activator -H3- to the remaining adhesive that was cut back.
Front rear-end well