Installing Rear Apron

Information 

Always replace self-locking screws.

1. Installation is performed in reverse order. Pay particular attention to the following:

Tightening torque for screws securing rear apron to retaining frame: > Tightening torque 3 Nm 

Tightening torque for screw securing rear apron to side panel: > Tightening torque 7 Nm 

Tightening torque for screws on tail light trim panel: > Tightening torque 6 Nm 

Tightening torque for screw securing rear apron to frame for light: > Tightening torque 3 Nm