Assembling Rear Lid
- Assembly is performed in reverse order.
- Screw in ball pin and tighten > Tightening torque 23 Nm (17 ftlb.)
- Screw in and tighten nuts on wiper motor retaining bracket > Tightening torque 8 Nm (5.9 ftlb.)
- Screw in and tighten screws in water drain sleeves > Tightening torque 4 Nm (3 ftlb.)
- Screw in and tighten screws in adjusting element > Tightening torque 6 Nm (4.4 ftlb.)