Preparing Rear Side Member (Section)

1. Fit in rear side member (section) and secure it to the body.
2. Drill bores for screws through the existing holes. > Diameter 3.5 mm 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Drilling holes

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Drilling holes

3. Remove rear side member (section).
4. Prepare rear side member (section) for bonding.

   > 5X00IN WORKING WITH BODY STRUCTURAL ADHESIVE

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Preparing rear side member (section)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Preparing rear side member (section)