Installing Rear Cross Member

Install rear cross member and check that it fits perfectly.
> 5X00IN GAP DIMENSIONS

Information
- Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
- The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
- Do not begin bonding work until all materials and tools necessary for later repair work are available.
Information
- Apply adhesive evenly over the entire bonding surface.
Apply adhesive on joint areas of the body. > Application depth 0.5 mm
Use body structural adhesive.

> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bonding areas of the body

Information
- Apply adhesive evenly over the entire bonding surface.
Apply adhesive on the rear cross member. > Application depth 0.5 mm
1. 3.1 Also apply a bead of adhesive all around the bonding surface. > Application depth 3 mm
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bonding areas on rear cross member
Only for Panamera Saloon
Install rear cross member.
1. 4.1 Rivet in rear cross member in area -A- . > BLIND RIVET 999.190.227.01
2. 4.2 Rivet in rear cross member in areas -B- . > FLOW-FORM RIVET 9A7.008.606.00
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rear cross member (Saloon)

Only for Panamera Sport Turismo

Install rear cross member.

5.2 Rivet in rear cross member in areas -B- . > FLOW-FORM RIVET 9A7.008.606.00

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rear cross member (Sport Turismo)