Removing Centre Cross Member

Information 

Shown on the left-hand side of the vehicle. The steps are identical for the right-hand side of the vehicle.

1. Bend up sheetmetal brackets -1-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Sheetmetal brackets

2. Disconnect connection points.
   1. 2.1 Drill out spotwelds in area -A-  .

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Spotwelds

   2. 2.2 Cut welded seams on the centre cross member.

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Welded seams

3. Remove centre cross member.