LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Macan T >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (38 Automatic Transmission Gears Control 2.9L -- 95B - MACAN (95B)) >> WM, 387719 Removing And Installing Control Mechanism For Transmission >> Subsequent Work >> Replacing Control Unit For Transmission

Replacing Control Unit For Transmission

WARNING: This page is about a different variant/trim than selected.

After replacing control mechanism for transmission: 

  1. Program control mechanism for transmission.

    Automatic programming.

    1. 1.1  Program control mechanism for transmission using the PIWIS Tester. 
    2. 1.2  Overview F12  PDK F12  Programming F12  Automatic programming F12 
    3. 1.3  Perform automatic programming
  2. Teach engine immobiliser.
    1. 2.1  Overview F12  Diagnostics F12  Online teaching functions > Engine immobiliser F12 
  3. Calibrate control mechanism for transmission. 

    Calibrate control mechanism for transmission using the PIWIS Tester. 

    1. 3.1  Overview F12  PDK F12  Maintenance/repairs F12  Calibration after replacing  mechatronics F12 
    2. 3.2  Follow the instructions on the PIWIS Tester. 
    3. 3.3  Start the calibration process by pressing
    4. 3.4  Erase fault memory.
  4. Code control mechanism for transmission. 

    Code control mechanism for transmission using the PIWIS Tester. 

    1. 4.1  Overview F12  PDK F12  Coding/adaptations F12  Automatic coding F12 
    2. 4.2  Perform automatic coding.
scientia non olet · About LEMON Manuals