Removing ATF Cooling Line (Rear Section)
WARNING: This page is about a different variant/trim than selected.
WARNING:
Working with ATF
- Possible danger of injury or damage (e.g. swollen hoses, skin irritation, danger of slipping, etc.)
→ Before lines are opened, place a cloth underneath them!
→ Components that come into contact with ATF must be cleaned IMMEDIATELY with water! → Take appropriate protective measures (protective clothing, safety goggles, oil binding material) → Collect emerging ATF!
NOTIFICATION
Dirt and contamination
- Risk of damage to units or components
→ Protect components from dirt and contamination.
→ Clean or replace dirty components.
- Guide out and remove ATF cooling line.