Subsequent Work
WARNING: This page is about a different variant/trim than selected.
- Secure both front drive shafts at the transmission side.
> 404119 - Removing and installing front drive shaft
- Install rear cardan shaft.
- Install power-steering gear.
> 489019 - Removing and installing power-steering gear
- Install front-axle support.
- Connect both sections of the line for ATF cooling
> 386219 - Removing and installing line for ATF cooling (V6 Turbo)
- Depending on model: Install particle filter/catalytic converter.
Vehicles with particle filter:
> 267419 - Removing and installing the particle filter (V6 Monoturbo/two-piece holder)
Vehicles without particle filter:
- Secure torque support to the engine.
> 103719 - Removing and installing torque support (V6 Turbo)
- Connect the battery.
> 270619 - REMOVING AND INSTALLING VEHICLE ELECTRICAL SYSTEM BATTERY