Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | be... | Type | Basic value | Tolerance1 | Tolerance2 |
|---|---|---|---|---|---|
| Bottom screw securing rear final drive to rear axle carrier | M10x92/replace | Initial tightening | 40 Nm (30 ftlb.) | ||
| Bottom screw securing rear final drive to rear axle carrier Rear axle housing, front to body | M14x1.5x135 thread/always replace screws following removal | Final tightening Initial tightening |
+ 90° 115 Nm | ||
| Rear axle housing, front to body | M14x1.5x135 thread/always replace screws following removal | Final tightening | + 90° |