Installing Heat Shield
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1
Tighten nuts on heat shields.
- Tightening torque 2 Nm (1.5 ftlb.)
- 1.2 For heat shield on lower baffle plate:
- 1.2.1
Tighten screws on outer air baffle plate.
- Tightening torque 3.5 Nm (2.5 ftlb.)
- 1.2.2
Tighten screws on inner air baffle plate.
- Tightening torque 2.5 Nm (1.75 ftlb.)
- 1.2.1
Tighten screws on outer air baffle plate.
- 1.3 For heat shield on cardan shaft centre bearing:
- 1.3.1
Tighten screws for stone guard.
- Tightening torque 20 Nm (15 ftlb.)
- 1.3.1
Tighten screws for stone guard.
- 1.1
Tighten nuts on heat shields.