Installing Centre Intake-Air Distributor
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Check centre intake-air distributor seals and replace if damaged.
- 1.2
Tighten screws securing centre intake-air distributor to intake-air distributors.
- Tightening torque 7 Nm (5 ftlb.)
- 1.3
Tighten screw on centre intake-air distributor.
- Tightening torque 8 Nm (6 ftlb.)