Installing Throttle Housing
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Replace throttle housing seal.
- 1.2
Tighten screws for throttle housing.
- Tightening torque 7 Nm (5 ftlb.)
- 1.3
Tighten screw-type clamp.
- Tightening torque 5.5 Nm (4 ftlb.)
- If the throttle housing was replaced:
Perform throttle valve adaptation using > 9900 - PIWIS Tester 3 .
In DME /Maintenance/repairs /Adaptations /Throttle valve