LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Macan T >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (53 - Body Rear) >> WM, 535555 Replacing Rear Side Panel >> Subsequent Work >> Subsequent Work For Body Repairs (Without Straightening System)

Subsequent Work For Body Repairs (Without Straightening System)

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean joint areas and sheetmetal flanges with a wire brush.
  2. Prime joint areas and sheetmetal flanges with 2-component primer.
  3. Restore standard seal with body sealant

    > *** 5X00IN42 Seam sealing

    Also seal the repair area carefully.

  4. Paint repair area and adjacent surfaces, if necessary.
  5. Restore standard underbody protection with underbody sealant

    > 5X00IN43 UNDERBODY PROTECTION

  6. Apply standard cavity preservation

    > 5X00IN44 CAVITY PRESERVATION

    Also apply cavity preservation to the repair area.

  7. Install removed add-on parts in the repair area.
scientia non olet · About LEMON Manuals