Preparing Rear Side Panel For Installation

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Fit rear side section.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rear side section
1. 1.1 Cut rear side section at the transitions to the body leaving an overlap of 30 mm.
Prepare connection areas for bonding and welding.
> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rear side panel

Red	Plug-welding/apply a full weld using inert gas without bonding
Green	Resistance spot-welding
Blue	Bonding