Preparing Connection Areas Of The Body For Installing C-Pillar Reinforcement
WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
- The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
- Do not begin bonding work until all materials and tools necessary for later repair work are available.
- Align the sealing surface and connections of the body.
- De-burr connection points and prepare them for welding.
- Prepare marked areas for welding and bonding.
Connection areas of body
> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00
| Red | Plug-welding/apply a full weld using inert gas without bonding |
| Green | Resistance spot-welding + bonding |
| Blue | Bonding |
| Orange | Resistance spot-welding |