Removing Rear Boot Floor Plate

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

Loosen connection points on one side only. Do not damage the sheet-metal panel underneath.

Drill out spotwelds using > VAS 882 001 - spotweld remover .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Spotwelds
1. 1.1 Only drill the spotwelds -LHD vehicle - through one plate thickness.
2. 1.2 Drill out spotwelds -RHD vehicle - through two plate thicknesses.
Heat bonding areas using > V.A.G 1416 - hot-air blower .
Remove rear trunk floor panel.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rear boot floor plate