Installing Rear Closing Panel

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
Do not begin bonding work until all materials and tools necessary for later repair work are available.

Install rear closing panel and check that it fits perfectly. Check gap dimensions.
> 5X00IN GAP DIMENSIONS

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Adhesive
1. 1.1 Apply foam filler to the body in area -A - .
  > 5X00IN22 WORKING WITH BODY FOAM FILLER
Make sure that all openings and gaps between the end plate and rear lock support are sealed with the sealing compound.
1. 1.2 Apply adhesive to marked areas. > Application depth 3.0 mm
  > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00
Resistance spot-weld the rear closing panel.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rear closing panel
1. 2.1 Plug-weld area -A and B- using inert gas.