Installing Safety Clip On Actuating Cylinder

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

G14362721

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Correct fitting

The actuating cylinder must be disconnected from the ball joint while removing and installing the safety clip.
Safety clips must not be removed or installed by widening (bending) them.
Replace safety clips that are widened as a result of incorrect removal.
Fit new safety clips only by pushing them on.

Fit safety clip in the top part of the groove.
Push safety clip on fully as far as its end position.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fitting the safety clip