Removing Control Unit For Rear Lid
WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Voltage peaks
→ Switch off ignition and keep transmitter key outsid. of the transmission range (at least 5 m).
→ Switch off electrical loads before disconnecting or removing them.
- Risk of damage to electrical load or to the control unit
→ Switch off ignition and keep transmitter key outsid. of the transmission range (at least 5 m).
→ Switch off electrical loads before disconnecting or removing them.
Information
Always comply with the regulations for handling ESD-sensitive components!
- Always wear approved work clothes and shoes when carrying out assembly work.
- Do not remove new parts non ESD (electrostatic discharge) protective packaging until shortly before installation.
- Do not touch electric pins and plug contacts.
- Disconnect electric plug connections -1-
and -3-
.
Electric plug connection
- 1.1 Release clip -arrow a- , swivel it aside -arrow b- and disconnect electric plug connection -1- from control unit for rear lid -2- .
- 1.2 Release electric plug connections -3- (-arrows c- ) and disconnect them from control unit for rear lid -2- .
- Release control unit for rear lid -1- (-arrows a-
) and slide it to the left out of the guides on the rear lid -arrow b-
.
Rear lid control unit