Removing Filler Flap (Module)

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

The filler flap (module) will be damaged during removal and must be replaced during installation.

Information

Remove the filler flap carefully so as not to damage the paintwork on the side wall.

Open the fuel tank cap -1- , unclip retaining strap -2- and pull it off.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fuel tank cap
2
Unhook emergency release button

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Emergency release button
Guide out operating cable for emergency release -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Emergency release for operating cable
Use a suitable tool to pierce all recessed areas and release the catches -Arrows- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Catches
Swivel filler flap (module) -1- out of the side panel, starting in the actuator area -Arrow- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Filler flap (module)
Release and disconnect electric plug connection -1- on the actuator -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric plug connection
Pull drain hose -1- off the filler flap (module).

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Drain hose