Removing Cross Panel

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Unscrew screws on cross panel -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screws on cross panel
Pull rubber sleeve -1- out of the cross panel and set electric wire harness -2- aside.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rubber sleeve
Unclip electric wire harness -2- at line brackets -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric wire harness
Pull vacuum line -3- off the line bracket -3- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Vacuum line
Unclip electric wire harness -1- at line brackets -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric wire harness
Unclip electric wire harness -1- at the line bracket -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric wire harness
Loosen coolant reservoir

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Coolant reservoir
1. 7.1 Unscrew screw -10- .
2. 7.2 Pull coolant reservoir -1- up out of the holders -11- and set aside with lines connected -7 and 9-.
Remove cross panel -1- by pulling it upwards.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Cross panel