Installing Cross Panel
WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order. Pay particular attention to the following:
Make sure that the cross panel is seated correctly in the seal -1- .
Seal
Tighten screw on the reservoir to > Tightening torque 8 (5.9 ftlb.) Nm .
Tighten screws on the cross panel to > Tightening torque 9 (6.5 ftlb.) Nm .