Removing front longitudinal member (front section)

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

The final dimension is measured from the new front side member (front section).
The cut is only permitted at this point in front of the internal reinforcement.
Ensure to make a straight cut.

Cut side member in accordance with the new part.

Fig 1: Checking Front Longitudinal Member (Front Section) Cutting Dimension
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Front longitudinal member (front section)
1. 1.1 Mark and make cuts all around. > Distance 158 mm
Fit sub-part using the straightening set. Cut side member to length as required.