LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Macan T >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (50 - Body Front) >> WM, 503819 Removing And Installing Lock Carrier >> Installing Lock Carrier

Installing Lock Carrier

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information 

Observe previously made marks on the body and align the lock carrier accordingly.

  1. Installation is performed in reverse order. Pay particular attention to the following:

    Tighten screws on carrier to > Tightening torque 55 (41 ftlb.) Nm  .

    Tighten screws on upper part of lock carrier to > Tightening torque 9.7 (7.5 ftlb.) Nm  .

    Tighten screws on lock carrier side section to > Tightening torque 9 7 (7.5 ftlb.) Nm  .

    Tighten screw for support to > Tightening torque 3.6 (2.6 ftlb.) Nm  .

    Tighten screws for refrigerant line holder to > Tightening torque 4.5 (3.25 ftlb.) Nm  .

scientia non olet · About LEMON Manuals