Removing Lock Carrier Side Section At The Left
WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
- For all work on the air-conditioning system that necessitates opening the refrigerant system, the system contents must first be disposed of in accordance with regulations.
- Dirt and moisture must be kept out of the air-conditioning system's pipes and hoses.
- Thorough cleanliness must be ensured during all work.
- System components must never be cleaned on the inside with hot steam.
- Only use nitrogen for cleaning.
- When replacing a component, all openings must be closed off using suitable stoppers immediately after opening the system.
- For R4 engine:
Loosen screw-type clamp -1- and pull charge air hose -2- off the charge-air cooler.
Left charge air hose on R4 engine
- Disconnect electric wire harness at the front -4-
.
Electric plug connections
- 2.1 Release and unplug electric plug connections -1- .
- 2.2 Release and disconnect electric plug connection -2- on airbag sensor.
- 2.3 Unclip line bracket -3- for electric wire harness at the front -4- and move electric wire harness at the front -4- aside and out of the work area.
- Loosen refrigerant lines -1-
at the connection point.
Refrigerant lines
- 3.1 Unscrew and remove screws -2- .
- 3.2 Disconnect refrigerant lines -1- at the connection point.
- 3.3 Close off refrigerant lines -1- using suitable stoppers.
- 3.4 Unscrew screw -3- and remove refrigerant lines -1- from the holder.
- Unscrew screw -1-
from left support -3-
.
Left support
- Disconnect coolant hose -2-
.
Coolant hose
- 5.1 Loosen safety clip -1- on coolant hose -2- .
- 5.2 Pull off coolant hose -2- and close off line connections using suitable stoppers.
- Unscrew screw -1-
and support the radiator assembly -2-
from below using a jack.
Cooler
- Unscrew and remove screws -2 and 3-
.
Left lock carrier side section
- Remove lock carrier side section at the left -3-
.
Cooler
- 8.1 Carefully pull the radiator assembly -2- forward.
- 8.2 Unclip holder -4- on lock carrier side section at the left -3- and remove lock carrier side section at the left -3- .