Installing Lock Carrier Side Section At The Left
WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
Radiator flange
- Sealing rings -2- must be replaced and coated with coolant.
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten screws to > Tightening torque 9.7 (7.5 ftlb.) Nm .
Tighten screw on radiator assembly holder to > Tightening torque 9.7 (7.5 ftlb.) Nm .
Tighten screw on refrigerant line holder to > Tightening torque 4.5 (3.25 ftlb.) Nm .
Replace O-rings en refrigerant lines.
Tighten screws for refrigerant lines to > Tightening torque 12 (9 ftlb.) Nm .