Removing Rear Level Sensor

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

Either two or four level sensors are installed on the vehicle, depending on equipment variant:

Steel springs without PASM: only left side of the vehicle (front and rear axle)
Air springs and steel springs with PASM: left and right side of the vehicle (front and rear axle)

Remove rear level sensor -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Level sensor
1. 1.1 Release and disconnect electric plug connection -2- .
2. 1.2 Unscrew screw on trailing arm -3- .
3. 1.3 Unscrew screw on rear axle housing -4- and counter at the nut.
4. 1.4 Remove rear level sensor -1- .