Installing Height Adjustment Control Unit
WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten fastening screw to > Tightening torque 2 Nm .
Subsequent work
- Install steering column centre.
- If the height adjustment control unit was replaced, the height adjustment control unit must be adapted to suit the vehicle using the PIWIS Tester.
> 483055 - REPLACING CONTROL UNIT FOR STEERING COLUMN ADJUSTMENT