Installing Atf Cooling Line (Front Section)

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Install front section of ATF cooling line -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

ATF cooling line - front section
1. 1.1 Fit front section of ATF cooling line
2. 1.2 Screw in and tighten screws on the ATF cooling line -2 and 3- .
  > Tightening - torque 5 Nm (3.5 ftlb.)
Connect ATF cooling line connection point.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Connection point for the ATF cooling line
1. 2.1 Fit front sections -3- on rear section.
2. 2.2 Screw on and tighten union nuts -1- and counter at the hexagon -2- at the same time.
  > Tightening - torque 29 Nm (21 ftlb.)