Installing Cover For Centre Underbody

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in reverse order. Pay particular attention to the following:
Tighten screws on cover for centre underbody at the left to > Tightening torque 2.5 (1.75 ftlb.) Nm .

Tighten nuts on left heat shield to > Tightening torque 2.5 (1.75 ftlb.) Nm .

Tighten nuts on holder to > Tightening torque 2.5 (1.75 ftlb.) Nm .

Tighten screws on rear side cover to > Tightening torque 2.5 (1.75 ftlb.) Nm .

Tighten screws on cover for centre underbody at the right to > Tightening torque 2.5 (1.75 ftlb.) Nm .

Tighten nuts on cover for centre underbody at the right to > Tightening torque 2.5 (1.75 ftlb.) Nm .

Tighten screws on right heat shield to > Tightening torque 2.5 (1.75 ftlb.) Nm .

Tighten nuts on right heat shield to > Tightening torque 2.5 (1.75 ftlb.) Nm .

Tighten screws on central cover for centre underbody to > Tightening torque 2.5 (1.75 ftlb.) Nm .

Tighten screws on central cover for centre underbody to > Tightening torque 3.5 (2.5 ftlb.) Nm .