Installing Inner Side Member

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Install inner side member and check that it fits perfectly. Check gap dimensions.

> 5X00IN GAP DIMENSIONS

Information

Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
Do not begin bonding work until all materials and tools necessary for later repair work are available.

1.1 Apply adhesive to marked areas. > Application depth 3.0 mm

> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Adhesive

Resistance spot-weld the inner side member at -LHD vehicle - and -RHD vehicle - .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Front inner side member
Resistance spot-weld the inner side member.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rear inner side member