Installing B-Pillar

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
Do not begin bonding work until all materials and tools necessary for later repair work are available.

Install outer B-pillar and check that it fits perfectly. Check gap dimensions.

> 5X00IN GAP DIMENSIONS

Information

Adhesive must not be applied to areas to be plug-welded or fully welded using inert gas.

1.1 Apply adhesive on marked areas. > Application depth 3.0 mm

> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Adhesive

Resistance spot-weld the B-pillar.

2.1 Resistance spot-weld area -A- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

B-pillar

Apply a full weld to the area -Arrows- using inert gas.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

B-pillar