Removing Roof

Information 

Only make cuts in the top plate. Make su'e not to damage the plate underneath when doing this.

Information 

Loosen connection points on one side only. Do not damage the sheet-metal panel underneath.

Information 

• During separation make sure that the components beneath are not damaged. 

1. Drill out spotwelds using > VAS 882 001 - spot-weld breaker  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Roof

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Roof

2. Affix adhesive tape -1-  along the edge of the roof on both sides at dimension -X-  . > Distance 15 mm + 2 mm 

   Adhesive tape serves as cut line.

   Fig 1: Checking Roof Adhesive Tape Cutting Dimension

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Roof

3. Make cut on both sides.
4. Heat connection areas using > V.A.G 1416 - hot-air blower  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Roof

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Roof

5. Remove roof (with the help of two people).
6. Remove remaining pieces of roof.
   1. 6.1  Cut off laser soldered joints on side panels.
   2. 6.2  Remove remaining pieces.

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Remaining pieces