Installing Coolant Pump

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

Coat all O-rings with Kluber Syntheso Glep 1.

Install coolant pump -9- .

Fig 1: Coolant Pump Screws Tightening Sequence
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Coolant pump screws
1. 1.1 Replace coolant pump seal.
2. 1.2 Position coolant pump -9- .
3. 1.3 Screw in screws for coolant pump -1 to 7- .
4. 1.4 Tighten screws for coolant pump in the sequence -1 to 7- .
  Stage 1 Screws -1 and 2- :
  - Initial tightening 9 Nm (6.5 ftlb.)
  Stage 2 Screws -1 to 7- :
  - Final tightening 9 Nm (6.5 ftlb.)
5. 1.5 Connect vacuum hose -8- .
Install coolant pipe over coolant pump -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Coolant pipe on cylinder head
1. 2.1 Replace O-rings.
2. 2.2 Position coolant pipe over coolant pump -1- .
3. 2.3 Screw in and tighten screws for coolant pipe -2- .
  - Tightening torque 9 Nm (6.5 ftlb.)
Install pulley -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Coolant pump pulley
1. 3.1 Position pulley -1- .
2. 3.2 Screw in and tighten screws for pulley -3- and counter at the same time using > T10172A - counter-hold tool-2- .
- Tightening torque 9 Nm (6.5 ftlb.)
Install coolant pipe -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Coolant pipe for coolant pump
1. 4.1 Replace O-rings.
2. 4.2 Position coolant pipe -1- .
3. 4.3 Screw in and tighten screws fro coolant pipe -2- .
- Tightening torque 9 Nm (6.5 ftlb.)