Installing Coolant Reservoir
WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1
Tighten screw on coolant reservoir.
- tightening torque 8 Nm (5.9 ftlb.)
- 1.2
Tighten screw on air inlet housing cover.
- Tightening torque 3.5 Nm (2.5 ftlb.)
- 1.1
Tighten screw on coolant reservoir.