Subsequent Work

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Install front air guide (at the top).
- WM, 192419 REMOVING AND INSTALLING FRONT AIR GUIDE (V6 TURBO)
V6 Turbo only:
Install pressure pipe (from charge-air cooler to charge-air cooler) at the top.
- WM, 214119 - REMOVING AND INSTALLING PRESSURE PIPE (V6 MONOTURBO)
Only for vehicles with distance measuring sensor:
Installing control unit for distance measuring sensor.
- WM, 278519 - REMOVING AND INSTALLING CONTROL UNIT FOR DISTANCE MEASURING SENSOR
Perform cooling-air flap adaptation:
1. 4.1 Perform cooling-air flap adaptation using the PIWIS Tester.
  1. 4.1.1 Connect the PIWIS Tester to the vehicle, start the PIWIS Tester and switch on ignition.
  2. 4.1.2 Select the DME control unit in the control unit overview.
  3. 4.1.3 In the Maintenance/repairs tab, select Adaptations and then sub-procedure: Select cooling-air flaps.
  4. 4.1.4 Follow the instructions on the PIWIS Tester.