Installing Exhaust System

1. 1.1  Position exhaust system -1-  on > VAS 6931 - engine and gearbox jack-2-  and secure with a tension strap -Arrows-  .
2. 1.2  Guide the exhaust system -1-  which is secured with a tension strap -Arrows-  , upwards using the > VAS 6931 - engine and gearbox jack-2-  and position it.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Exhaust system on VAS 6931 engine and gearbox jack (similar to illustration)

1. 2.1  Connect and lock electric plug connection -7-  on servo motor for flap control -8-  .
2. 2.2  Screw on nuts -4 and 5-  and fit screws -6-  , but do not tighten them yet.
3. 2.3  Slide new clamp -2-  onto exhaust pipes at the vehicle side and align it so that the threaded joint is not lower than the exhaust pipe.
4. 2.4  Tighten nuts on clamp -3-  .
   • Tightening torque 30 Nm (22 ftlb.) 
5. 2.5  Tighten nuts -4 and 5-  .
   • Tightening torque 20 Nm (15 ftlb.) 
6. 2.6  Tighten screws -6-  .
   • Tightening torque 20 Nm (15 ftlb.) 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Exhaust system

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Exhaust system on VAS 6931 engine and gearbox jack (similar to illustration)