Installing Camshaft Sensor (Outlet Camshafts)
WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order, paying particular attention to the following:
- 1.1 Replace O-ring on camshaft sensor for outlet camshafts.
- 1.2 Apply a light coat of Kluber Syntheso Glep O-ring on camshaft sensor for intake camshafts.
- 1.3
Tighten screw on camshaft sensor.
- Tightening torque 9 Nm (6.5 ftlb.) (6.6 ftlb.)