Install Camshaft Sensor (Intake Camshafts)

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in reverse order. Pay particular attention to the following:
1. 1.1 Replace O-ring on camshaft sensor for intake camshafts.
2. 1.2 Grease O-ring on hall sender for intake camshafts w ith a light coating of Kluber Syntheso Glep.
3. 1.3 Tighten screw on camshaft sensor.
  - Tightening torque 9 Nm (6.5 ftlb.) (6.6 ftlb.)