Removing Ignition Coils (Right Cylinder Bank)

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

Before doing any other work, the ignition must be switched off and the remote control (hand-held transmitter) must be kept outside of the transmission range (at least 2 m).

Only when removing ignition coils for cylinder 2 or 3:
Remove torque support bracket -1- .
1. 1.1 Unscrew screws -2 and 3- .
2. 1.2 Remove torque support bracket -1- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Torque support bracket
Only when removing ignition coils for cylinder 2 or 3:
Loosen cable duct for engine wire harness -1- .
1. 2.1 Unclip line -2- from the cable duct -1- .
2. 2.2 Release and disconnect cable plug -3- .
3. 2.3 Pull cable duct -1- off ball pins and set it aside.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Cable duct for engine wire harness, right
Remove ignition coils -1- .
1. 3.1 Unscrew screws on ignition coils -2- .
2. 3.2 Pull off ignition coils -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Ignition coils on right cylinder bank