Installing Ignition Coils (Right Cylinder Bank)

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Install ignition coils -1- .
1. 1.1 Insert ignition coils -1- .
2. 1.2 Screw in and tighten screws on ignition coils -2- .
  - Tightening torque 9 Nm (6.5 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Ignition coils on right cylinder bank
Only when removing ignition coils for cylinder 2 or 3:
Secure cable duct -1- .
1. 2.1 Fit cable duct -1- on the ball pin.
2. 2.2 Clip line -2- into cable duct -1- .
3. 2.3 Connect and lock cable plug -3- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Cable duct for engine wire harness, right
Only when removing ignition coils for cylinder 2 or 3:
Install torque support bracket -1- .
1. 3.1 Fit torque support bracket -1- .
2. 3.2 Screw in and tighten screws -2 and 3- .
  Screw -2- :
  - Tightening torque 20 Nm (15 ftlb.)
    Screw -3- :
  - Tightening torque 55 Nm (41 ftlb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Torque support bracket