Installing Fuel Line (High-Pressure, Right)

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in reverse order. Pay particular attention to the following:

1.1 Coat thread on union nuts -2 and 3- with Microgleit DF 977S. Observe a drying time of at least 5 minutes before fitting.
1.2 Screw in and tighten screw -4- .
- Tightening torque 9 Nm (6.6 ftlb.)

1.3 Tighten union nuts -2 and 3- using > V.A.G 1331/6 - Open-jawed wrench insert, a/f 17 .

tightening torque of 10 Nm (7.4 ftlb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installing fuel line

1.4 Tighten screws on torque support bracket -2- .
- Tightening torque 20 Nm (15 ftlb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Torque support bracket