Removing DME Control Unit

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

NOTIFICATION

Voltage peaks

Risk of damage to electrical load or to the control unit
1. → Switch off ignition and keep transmitter key outside of the transmission range (at least 5 m).
2. → Switch off electrical loads before disconnecting or removing them.

Information

Always comply with the regulations for handling ESD-sensitive components!

Always wear approved work clothes and shoes when carrying out assembly work.
Do not remove new part from ESD (electrostatic discharge) protective packaging until shortly before installation and only at the installation position.
Do not touch electric pins and plug contacts.

Information

The number of electric plug connections will vary depending on equipment.

Release and disconnect electric plug connections -2- on the DME control unit -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric plug connections
Release retaining lugs -2- and remove DME control unit -1- from the holder.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

DME control unit