Installing Throttle Housing
WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Replace throttle housing seal.
- 1.2
Tighten screws for throttle housing.
- Tightening torque 7 Nm (5 ftlb.)
- 1.3
Tighten screw-type clamp.
- Tightening torque 5.5 Nm (4 ftlb.)